Loading ...
Loading ...
Loading ...
24
Troubleshooting
Problem Possible cause Possible solution
Acoustic alarm,
display shows
ALARMCODE
The appliance does
not fill with water.
Water tap is closed.
Open the water tap.
Note: Whenever Error is
s o l v e d s w i t c h o f f t h e
appliance and restart the
programm.
Water inlet hose has a kink or
a bend.
Make sure that the position of
the hose is correct.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
The hose must be replaced.
Filter in the water inlet hose
is clogged.
Clean the filter at the inlet
hose connections at tap and
the rear of the appliance.
Water inlet is clogged. Check water flow from tap.
Water pressure is too low.
Contact your local water
authority.
Acoustic alarm,
display shows
ALARMCODE
The appliance does
Filters are clogged.
• Scoop out as much water as
possible.
• Clean filters.
• Continue programme by
pressing the START/PAUSE
button.
The drainage is blocked.
• Scoop out as much water as
possible.
• M a k e s u r e t h a t d r a i n
water connection and piping
is correct and not blocked.
• Continue programme by
pressing the START/PAUSE
button.
Acoustic alarm,
display shows
ALARMCODE
Leak: The drain
pump
runs permanently!
Anti- flood device is on:
• There are water leakages in
the appliance.
• The water inlet valve is
open and blocked.
• The drainage is blocked.
1.Close the water tap.
2.Disconnect appliance from
power supply.
3.Contact Service.
Error codes on the display
All other Alarmcodes:
1. Note Alarmcode
2. Contact Service ; refer to CUSTOMER SERVICE
E20
E30
E10
Or all LED lights
flash once every 3s
Or all LED lights
flash twice every 3s
Or all LED lights
flash 3 times every
3s
Loading ...
Loading ...
Loading ...