Loading ...
Loading ...
Loading ...
Black plate (46,1)
1
2
1 Microphone clip
2 Clamp
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
When installing the microphone
on the steering column
1 Detach the microphone base from the mi-
crophone clip.
To detach the microphone base from the micro-
phone clip, slide the microphone base.
1
2
3
1 Microphone
2 Microphone clip
3 Microphone base
2 Install the microphone on the steering
column.
1
2
3
1 Double-sided tape
2 Install the microphone on the rear side of the
steering column.
3 Clamp
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
Adjusting the microphone angle
The microphone angle can be adjusted.
Troubleshooting
Common
Symptom Cause Action (Refer-
ence page)
The power
will not turn
on.
The unit will
not operate.
Leads and con-
nectors are in-
correctly con-
nected.
Confirm once
more that all con-
nections are cor-
rect.
The fuse is
blown.
Rectify the cause
and then replace
the fuse. Be sure
to install a fuse
with the same rat-
ing.
Noise and/or
other factors
are causing the
built-in micro-
processor to op-
erate incor-
rectly.
Press RESET.
(Page 39)
Operation
with the re-
mote control
is not possi-
ble.
The unit does
not operate
correctly even
when the ap-
propriate re-
mote control
buttons are
pressed.
Battery power is
low.
Load a new bat-
tery.
Some opera-
tions are prohib-
ited with certain
discs.
Try operating with
another disc.
Symptom Cause Action (Refer-
ence page)
Playback is
not possible.
The disc is dirty. Clean the disc.
The type of disc
loaded cannot
be played on
this unit.
Check the disc
type.
The disc loaded
is not compati-
ble with this
video system.
Change the disc
to one that is
compatible with
your video sys-
tem.
There is no
sound.
The volume
level will not
rise.
Cables are not
connected cor-
rectly.
Connect the ca-
bles correctly.
The unit is per-
forming still,
slow motion or
frame-by-frame
playback.
There is no sound
during still, slow
motion or frame-
by-frame play-
back.
There is no
image dis-
played.
The parking
brake cable is
not connected.
Connect the park-
ing brake cable,
and apply the
parking brake.
The parking
brake is not ap-
plied.
Connect the park-
ing brake cable,
and apply the
parking brake.
The
icon is
displayed,
and operation
is not possi-
ble.
The operation is
prohibited for
the disc.
This operation is
not possible.
The operation is
not compatible
with the config-
uration of the
disc.
This operation is
not possible.
Installation
46
Section
Additional information
En
24
<CRD4711-C>46
Loading ...
Loading ...
Loading ...