Loading ...
Loading ...
Loading ...
11
USING YOUR STEAM MOP
Preparing for use
Make sure your floors are vacuumed/swept before using the steam mop.
Using
1. Twist the cord release, plug the steam mop into a mains socket and switch
the power on.
2. Make sure the water tank is filled, following instructions on page 10.
3. Turn the power dial clockwise from the ‘OFF’ to the ‘ON’ position.
4. The power light should be illuminated red. Wait approximately 30 seconds
for the water to heat sufficiently and the steam mop is ready to use.
5. In the upright position, the mop will not steam. Tilt the steam mop
backwards, approximately 45°, and it will begin to steam.
6. Move the steam mop forwards and backwards over the areas you wish to
steam clean.
Note: When using the steam mop, do not leave it over a particular area for
more than 30 seconds. This could cause damage.
If the steam flow slows down or stops the unit may need refilling with water.
To refill the water tank: unplug the unit and allow to cool, then follow
instructions on page 10.
Loading ...
Loading ...
Loading ...