Loading ...
Loading ...
Loading ...
Crisper Operation
CONCERN WHAT TO DO
Excess moisture build up in crisper
It is normal for there to be some
moisture and humidity in the crisper bin.
Ensure that the crisper is not over packed.
Adjust crisper humidity slides.
Crisper bin can not be removed If crisper bin interferes with the door bins, remove door bins before
removing crisper.
Position cabinet so that the door can be fully opened.
Freezing items in the crisper Adjust temperature to a warmer setting.
Refrigerator operation
CONCERN WHAT TO DO
Appliance will not run
It is normal for the freezer fan not to
operate during the automatic defrost
cycle, or for a short time after the
appliance is switched on.
Ensure that the cord is plugged into a live power outlet and outlet is switched on.
Ensure that the household circuit
breaker has not tripped or that the fuse has not
blown.
The appliance maybe in defrost mode, check again in half an hour.
Compressor motor seems to run
too long
At normal room temperatures, expect
your motor to run about 40% to 80%
of the time. Under warmer conditions,
expect it to run more often.
Ensure that the doors are not held open
Check that large amounts of warm food
have not just been placed inside the appliance.
Note that the appliance will run more than normal just after you install it or when
adjusting the temperature setting changes.
TROUBLESHOOTING
The variable speed compressor and fan that at start up and on warm days, runs at high
speeds to provide additional cooling. When less cooling is required the compressor and
fan will run at a lower speed, but still may not switch o. This is normal.
The exterior of the appliance is warm
or hot to touch
This is normal because the appliance
transfers heat from the inside out
through the outer panels and the
divider between the doors.
Compressor motor seems to run too
long for WTB4600, WTB4604,
WTB5400, WTB5404, WBE4500,
WBE4504, WBE5300, WBE5304,
WRB5004, WFB4204, WHE5204,
WHE5264, WQE6060, WQE6000,
WHE6060, WHE6000only. These
appliances use a variable speed
compressor, which by design can
run for lo
ng periods of time, this is
normal
User interface will not respond
To ensure settings are not accidentally
changed the user interface will go into
sleep mode when not in use. Press any
button to wake user interface
Check that the user interface is in awake mode, refer to section “About the user interface”
.
Check that the user interface is not locked, refer to section “About the user interface”.
If the user interface is frozen turn the appliance o for five minutes for the memory to
clear, then turn back on.
Check that the user interface is not in Sabbath Mode, refer to control instructions. (I&W
models only).
It is possible that the only time the compressor and fan will stop is when the refrigerator
is defrosting which is approximately once per
day.
Ensure the appliance has the external clearances recommended in the section “Installing
your new appliance”.
The exterior of the cabinet will be much warmer on warmer days it may even feel hot to
touch, as the appliance is working harder.
TROUBLESHOOTING 29
Loading ...
Loading ...
Loading ...