Loading ...
Loading ...
Loading ...
Please read before beginning installation.
The water connection to your ice and water product can be
self installed. However, it is recommended that you seek
advice from a licensed plumber before commencing the
installation.
IMPORTANT
Check for water leaks at all water connection points in the
first 2 to 3 hours after installation, and correct it in case of
any water leak. Recheck after 24 hours; if leak still occurs, it
is recommended to contact a licensed plumber for advice.
Water is to be connected as per diagram below.
(WHE5264 shown)
Step 6.
Reconnect the power.
Step 7.
Move the refrigerator back into place being careful not to kink
or split the tubing.
Step 8.
Switch ON Water Dispenser.
By referring to Ice & Water on/off
function on page no.21
Using a large container, run the
water dispenser to clear air from lines. This may take a few
minutes. Purge and dispense a minimum of 2 litres of water.
Initial water may be black in
colour. This is residual carbon dust
from the filter and is non-toxic.
If the water is slow to shut off or
the dispenser is dripping, air may
still be in the lines. Either purge
more water through the system
to remove this air or allow some
time for the air to be removed
over subsequent dispensing. For
normal use, water dispenser will
automatically shut off after 2
minutes of continuous operation.
IMPORTANT
As the water cut off is not instant, leave glass under
dispenser briefly until water has stopped flowing to avoid
spills.
Clean and empty the dispenser drip tray regularly to avoid
overflow.
If you have not used the dispenser for some time, discard the
first seven or eight cups of water (contaminants could have
settled in the water pipes).
Step 9
Switch ON Ice Maker.
Once the refrigerator has been running for at least 24 hours
remove the ice bin and dispose of the first few batches of ice
to ensure that impurities have been flushed from the system.
CAUTION
Water dispenser should not be used for extended periods of
time. After 2 minutes of continuous use the water dispenser
will automatically shut off.
Party Ice
When the Ice Bin is removed from the cabinet the
Auto Ice Maker will continue to dispense ice into the top
freezer drawer.
Step 1.
Ensure that the refrigerator is
disconnected from power
supply.
Step 2.
Connect tap fitting to water
supply tap. Tap must be close
to the refrigerator.
Step 3.
Push the tube into tap fitting
past insertion mark.
Step 4.
Connect other end of tube to inlet on rear of refrigerator.
Step 5.
Turn on water and check all
joints and tubes for leaks.
INSTALLATION 15
Loading ...
Loading ...
Loading ...