Loading ...
Loading ...
Loading ...
Page 7
Installation
UNPACKING
Unpack the mixer immediately after receipt. If the machine is found to be damaged, save the packaging material
and contact the carrier within 15 days of delivery. Immediately contact your source of the equipment.
You have no recourse for damage after 15 days.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYS install equipment in work area with adequate light and space.
• ONLY operate mixer on a solid, LEVEL, non-skid surface that is nonammable.
• NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so can create
hazards and will void the warranty.
• NEVER operate mixer without all warnings attached.
• DO NOT attempt to lift mixer alone.
INSTALLATION
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have questions or do not understand everything in this manual. Contact your local
representative or Globe rst.
2. Remove the corrugated box from the skid by removing the bands on the box.
3. Remove all packaging and bands that secure the spiral mixer to the inner skid.
4. Select a location for the mixer keeping these points in mind:
• Floor must be level.
• Sufcient space for the bowl guard to be raised above the mixer.
• Easy access for maintenance and service.
• Clearance for operating controls.
• Sufcient space for adding ingredients during mixing periods.
5. Secure the two front legs to the oor. Remove the two xed covers located on the sides of the base.
6. Use the hex wrench socket (16 mm), supplied with the mixer, to loosen the lock nut until the thread of each leg
is disclosed and the two faces show up.
7. Turn the leg shafts with the hex wrench socket (16 mm) until there is no more stress on the front wheels.
NOTE: The front wheels must be able to rotate freely.
8. Use the hex wrench socket (16 mm) to tighten the two lock nuts so that the feet stand at on the oor.
9. Read the electrical information found on the data plate located at the rear of the machine. The incoming
power must match the rating on the data plate.
CONNECTING TO ELECTRICAL POWER
Cord Connected Units: This machine needs to be hard-wired, have a licensed electrician connect the unit
to the power supply. Never use an extension cord. Low power supply could damage the mixer and/or
cause a re.
Loading ...
Loading ...
Loading ...