Loading ...
Loading ...
Loading ...
Bulb Number
Auxiliary Liftgate
Tail Lamps
LED - (Service At
Authorized Dealer)
Liftgate Backup
Lamps
921 (W16W)
Rear License Lamps
LED - (Service At
Authorized Dealer)
Rear Body Side
Stop/Turn Lamps
3157KRD LCP
(P27/7W)
Rear Body Side
Tail Lamps
LED - (Service At
Authorized Dealer)
CHMSL - Center
High Mounted
Stop Lamp
LED - (Service At
Authorized Dealer)
NOTE:
Numbers refer to commercial bulb types that
can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your
authorized dealer or refer to the applicable
Service Manual.
Bulb Replacement
High Intensity Discharge Headlamps (HID) —
If Equipped
The headlamps are a type of high voltage
discharge tube. High voltage can remain in
the circuit even with the headlamp switch off
and the key removed. Because of this, you
should not attempt to service a headlamp bulb
yourself. If a headlamp bulb fails, take your
vehicle to an authorized dealer for service.
WARNING!
A transient high voltage occurs at the bulb
sockets of High Intensity Discharge (HID)
headlamps when the headlamp switch is
turned ON. It may cause serious electrical
shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE:
On vehicles equipped with High Intensity
Discharge (HID) headlamps, when the head-
lamps are turned on, there is a blue hue to the
lamps. This diminishes and becomes more
white after approximately 10 seconds, as the
system charges.
Halogen Headlamps — If Equipped
NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as
atmospheric conditions change to allow the
condensation to change back to vapor. Turn-
ing the lamps on will usually accelerate the
clearing process.
1. Open the hood.
2. Access the back of the headlamp.
NOTE:
• The air filter housing must be removed.
• The windshield washer reservoir may
need to be rotated out of the way by
removing the fastener.
• Coolant reservoir (if equipped) will
need to be repositioned by removing the
fasteners, and moving the unit out of
the way.
3. To access the low beam bulb you must
remove the rubber boot seal from back-
side of the lamp housing.
207
Loading ...
Loading ...
Loading ...