Loading ...
Loading ...
Loading ...
Installation/Owner's Manual
2-31
2. Installing ACP
Setting the netmask address
After setting the gateway address, the netmask address should be set. Set the netmask address as follows:
1. Press the 'MENU/SELECT' button of the ACP and then press Left/Right ( , ) button to display
the following Netmask setup screen. Press the 'MENU/SELECT' button again. The screen to enter
the netmask address is displayed.
MENU/
SELECT
[MENU]
Set Netmask
[Set Netmask]
192.168.000.000
MENU/
SELECT
Click
MENU
/SELECT
button
Example to set Netmask address
[Set Netmask]
255.255.255.000
MENU/
SELECT
ACP
SW ver. 2.77.2
2. Use Up/Down/Left/Right ( ) button to enter the desired net mask address.
3. After entering the netmask address, press the 'MENU/SELECT' button to set the entered netmask
address. But, there is no 'MENU/SELECT' button pressed for a specific period (about 5 seconds), it
returns to the initial screen with the entered netmask address not applied to the system, and the
existing set netmask address is used.
Loading ...
Loading ...
Loading ...