Loading ...
Loading ...
Loading ...
8
The Knobs on the Front
The Le Knob
Input
Rotate the Left Knob to choose between non-wireless
inputs: USB, HDMI, AUX and OPT. Turning the knob
will stop wireless playback. Wireless inputs can only be
accessed remotely. Current input will illuminate.
Bluetooth Pairing
Pressing and holding the Left Knob for two seconds will
put the RS200 into Bluetooth Pairing Mode as described
in ”Other Wireless Connections” on page 5.
NET Wi-Fi Status LED
Solid Light Connected to a wireless router
Rapid Blinking Booting up
Blinking Connecting to wireless router
Two Blinks and a
Pause
WPS- Wi-Fi Protected Mode
setup
Slow Pulse Access Point set-up mode.
The green NET LED indicates the status of the network
connection. If you hold the Wi-Fi symbol for 8
seconds as descibed in the Play-Fi Setup section, the
NET LED will progress through Rapid Blinking and
Blinking before reaching the Slow Pulse indicating that
it is in set-up mode.
Meter Brightness
Pressing and turning the Left Knob will adjust meter
brightness. Clockwise for brighter and counterclockwise
for less bright or off.
The Night button on the remote will toggle the meter
lights on and off. In this Night Mode, when the input
changes, the input LED will remain lit for 5 seconds and
then shut off.
The Right Knob
Standby
When the RS200 is in operating mode, pressing and
holding the Right Knob for two seconds will place the
unit into Power Save Mode. Press the Right Knob to
return to operating mode. When the unit is in the Power
Save Mode, the RS200 still works With Alexa™. The
RS200 will also enter Power Save Mode if no signal
or restart command occurs after 30 minutes. If no
signal or restart command occurs after 60 minutes in
Power Save Mode, the RS200 will enter Standby Mode.
Standby Mode power consumption is less than 0.5 W.
Startup from Standby Mode requires extra time to re-
establish the Wi-Fi connection. The Standby function
can be enabled in the Play-Fi app under Power Sleep
Timer in the Advanced Settings menu. The default is
disabled.
Mute
A short press of the Right Knob for a half second or
less will toggle the Mute function. The Red LED below
the knob will ash for about 5 seconds when muted
or volume is reduced to zero with the Right Knob as
described below.
Volume
Turn the Right Knob clockwise to raise the volume and
counterclockwise to lower it. Turning the knob either
way will unmute the sound. Lowering the volume to
silent will mute the sound (by denition).
When maximum volume is reached, a Red LED above
the knob will ash for about 5 seconds .
Both Knobs
Reseng the Unit
Pressing both knobs for 10 seconds will restore the unit
to factory settings. Holding the knobs in for 5 seconds
will produce a test tone and erase Bluetooth pairing info
as well as stored Presets.
The Grilles
The two Grilles covering the Speaker Array on the left
and right of the front of the RS200 can be removed by
pulling straight out from the unit. The Grilles are held in
place by 6 Grille Mounting Pins. To reattach the Grille,
line up the 6 Mounting Pins with the 6 holes and press
Left
Knob
Right
Knob
Figure 8– Knob Locations
Loading ...
Loading ...
Loading ...