Loading ...
Loading ...
Loading ...
10
Changing the Remote’s Baery
Someday, the AAA battery in the remote will need to
be replaced. This is how to do it.
The back of the remote control is held in place by
magnets. To remove the back of the remote to reveal the
battery, slide the front of the remote up while sliding
the back of the remote down. The goal is to move the
back 3/16 of an inch from the top of the remote and
then lift it off. There are many ways do to this, as far as
positioning your ngers. To open the remote:
• Hold the remote upsidedown and backwards with
McIntosh name upsidedown and facing away from
you. The thicker end will now be the top and you
should be staring at the back of the remote.
• Pinch the remote with your index nger resting
on the Trim/Select button and your thumb on the
backside (facing you) opposite your index nger’s
position. Your thumb and remote should both be
pointing away from you (see Figure 9).
• Use your thumb to slide the back open 3/16 of an
inch. Slide your thumb away from you towards the
thicker end of the remote, while your index nger
goes in the opposite direction (towards you). As if
snapping your ngers in slow motion. For added
strength, you can use your other hand in a similar
position above your rst hand using the same
technique. Make sure you do not hold the side
edge with either hand.
• Lift the back off with your other hand before it
snaps closed again. You can grab the now exposed
top edge.
• It gets easier after the rst time.
Remove and replace the battery noting the polarity
(printed below the battery if you forget).
To replace the back: Place the back in position 3/16 of
an inch from the edge. The magnets will help you snap
it back into place.
Figure 9– Sliding open the remote
QQ Music
QQ Music is China’s largest music streaming service
and offers tens of millions of tracks and thousands of
radio stations. QQ Music has free and premium tiers,
and both local and international content.
NPR
The NPR service provides access to vast amounts of
NPR’s programming.
DEEZER
Deezer offers over 53 million tracks and millions of
playlists. You can browse curated collections by genre
and explore everything from Top 40 to unsigned acts.
Using Presets
Presets are a new feature of the Play-Fi operating
experience. Four presets (1, 2, 3, 4) can be stored for
one button access. The preset numbers can be accessed
from the top front of the RS200 or from the remote
control. Currently, these presets can be Internet Radio,
iHeartRadio, Tidal, Spotify and Pandora but more
services will be added to the preset feature.
To store a preset, push and hold the desired number for
5 seconds. A new preset will be stored and any existing
preset in that spot will be overwritten. To recall the
preset simply push the button.
Remote Learning
The RS200 is capable of learning some commands from
most television IR remotes. This is handy to control the
volume of the RS200 that is optically connected to a
television with only the television remote.
To teach the RS200 the other remote’s commands:
Press Result
Press and hold the Left
Knob for 10 seconds.
Power Meter lights will
blink twice. Max Volume
LED will blink twice per
second.
Press the remote button
to be learned for volume
increase.
Power Meter lights will
blink twice. Min Volume
LED will blink twice per
second.
Press the remote button
to be learned for volume
decrease.
Power Meter lights will
blink twice. Min Volume
LED will blink twice
every 4 four seconds.
Press the remote button
to be learned for mute.
Power Meter lights will
blink twice. The Max
Volume LED will glow
steady.
Press the remote button
to be learned for standby
toggle.
Power Meter lights blink
three times, LED state
changes from steady to
off indicating learning
session has ended.
Loading ...
Loading ...
Loading ...