Loading ...
Loading ...
Loading ...
10
EN
• Position the power supply cable in such a way
that it is not resting against the rear of the
oven, that it is not in contact with sharp edges
and will not reach a temperature of 90°C at
any point.
• Do not use adapters, extension leads, gang
sockets etc. as these could cause loose
contacts and overheat.
Hard-wired to the mains circuit:
• The circuit must be fi tted with a omnipolar
circuit breaker of suitable capacity for the
appliance's rated load.
• The earth conductor must not be switched
by the breaker and must be connected to the
earthing system.
• As an alternative, an RCBO may also be used,
or RCD protection in addition to or instead of
a fuse or MCB, depending on the applicable
electrical code.
REPLACING COMPONENTS
Isolate the appliance’s power supply before
performing any maintenance.
Contact an authorised service centre if functional
components require replacement.
WARNING: If the power cable requires
replacement, the installer/maintenance
technician must use H05VV-F cable and leave
the earth conductor around 2 cm longer than
the live and neutral wires. They must also
comply with the instructions given for the
electrical connection.
/ Installation
MAINTENANCE
M
AINTENAN
CE
ELECTRICAL CONNECTION
Loading ...
Loading ...
Loading ...