Vacmaster VWM510 5-Gallon 5 Peak HP Remote Control Wall Mount Wet/Dry Shop Vacuum

cartridge filter should be used for dry pick-up and small amounts of liquids. A dry cartridge filter is necessary

to pick up dust. If the cartridge filter is wet, it will clog quickly and be difficult to clean. Handle the filter

carefully when removing it for cleaning and replacing it. Check the filters for tears or small holes, a small

hole can let dust pass through and out of the cleaner. Do not use a filter with holes or tears in it, replace it

immediately.

1. Verify that the power cord is disconnected from the outlet.

2. Remove power head and place in upside down position.

3. Install the cartridge filter over the filter cage with the flat end of the filter towards the vacuum power head.

Carefully push filter in until it stops against the power head. (fig. 1 & 2)

4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning retainer

Clockwise, do not over tighten. (fig. 3 & 4)

1. Unlock and remove the filter retainer by turning retainer handle counter clockwise.

2. Carefully hold and pull the cartridge filter up for removal. (fig. 5)

3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done indoors in

1. Verify that the power cord is disconnected from the outlet

1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 3)

2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 4)

3. Allow filter to air dry before installing and using again.