Loading ...
Loading ...
Loading ...
10
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Make sure the container is empty before using as a blower.
3. Remove the noise diffuser from the blower port. (fig. 2)
4. Remove hose from the vacuum port and insert the locking end of the hose into the blowing port on the
power head and lock into position. (fig. 3)
5. Fit the desired extension wand and or nozzle to the free end of the vacuum hose. (fig. 4)
6. Ensure the power switch is turned off and plug in the power supply. (fig. 5)
7. Before turning ON the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the ‘I’ ON position or use the vac with switch set to remote control setting and the remote control. (fig. 6)
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Disconnect the hose from the vacuum. (fig. 2)
3. Remove the vacuum from the mounting rack.
4. Undo the latches and remove the power head from the container. (fig. 3)
5. Clear all dirt or debris from the container and hose. (fig. 4)
6. Clean the foam filter by washing it with water and mild soap. (fig. 5)
7. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter, the
motor will burn out and the warranty will be voided. Always keep spare filters on-hand.
MAINTENANCE
BLOWING OPERATION
Loading ...
Loading ...
Loading ...