Loading ...
Loading ...
Loading ...
Part Number: 000014141 Rev 03 2/18 41
Section 4 Maintenance
Step 2 Remove all ice from the bin/
dispenser.
Step 3 Press the Clean button and select
“Turn off when complete”. Water will flow
through the water dump valve and down
the drain. Wait approximately 1 minute
until the water trough refills and the display
indicates Add Chemical. Add the proper
amount of ice machine cleaner to the water
trough by pouring between the water
curtain and evaporator, then confirm the
chemical was added.
Model
Amount of
Cleaner
IF0300/IT0420/IT0620
3 oz
(90 ml)
IT0450/IT0500/IF0600
IF0900/IT1200
5 oz
(150 ml)
IBF0620C/IBF0820C
IBT1020C
5 oz
(150 ml)
IF1400C/IT1500/IF1800C
IT1900/IF2100C
9 oz
(265 ml)
Step 4 Wait until the clean cycle is
complete (approximately *24 minutes).
Then disconnect power to the ice machine
(and dispenser when used).
n
Warning
Disconnect the electric power to the ice
machine at the electric service switch box.
Step 5 Remove parts for cleaning.
Refer to parts removal page 43. Continue
with Step 6 when the parts have been
removed.
Step 6 Mix a solution of cleaner and
lukewarm water. Depending upon the
amount of mineral buildup, a larger
quantity of solution may be required. Use
the ratio in the table below to mix enough
solution to thoroughly clean all parts.
Solution
Type
Water Mixed With
Cleaner 1 gal (4 L)
16 oz
(475 ml)
cleaner
Step 7 Use half of the cleaner/water
mixture to clean all components. The
cleaner solution will foam when it contacts
lime scale and mineral deposits; once the
foaming stops, use a soft-bristle nylon
brush, sponge or cloth (NOT a wire brush)
to carefully clean the parts. Soak parts for 5
minutes (15 - 20 minutes for heavily scaled
parts). Rinse all components with clean
water.
Loading ...
Loading ...
Loading ...