Loading ...
Loading ...
Loading ...
20 Part Number: 000014141 Rev 03 2/18
Installation Section 2
Water Supply and Drain Line Sizing/Connections
,
Caution
Do not apply heat to water inlet valve or water drain fittings. Heating will damage the
nonmetallic connector. Do not over tighten fittings. Two turns after hand tight is the
maximum.
• Local water conditions may require treatment of the water to inhibit scale formation,
filter sediment, and remove chlorine odor and taste.
• Connect ice making water inlet to potable water only.
• Do not connect to hot water supply.
• Install a water shut-off valve.
• Insulate water and drain lines to prevent condensation.
Location
Water
Temperature
Water Pressure
Ice Machine
Fitting
Tubing Size up
to Ice Machine
Fitting
Ice Making
Water Inlet
40°F (4.4°C) Min.
90°F (32°C) Max.
20 psi (140 kPa)
Min.
80 psi (550 kPa)
Max.
3/8" Female Pipe
Thread
3/8" (10 mm)
minimum inside
diameter
Ice Making
Water Drain
— —
1/2" Female Pipe
Thread
1/2" (13 mm)
minimum inside
diameter
Condenser Water
Inlet
40°F (4.4°C) Min.
90°F (32°C) Max.
20 psi (140 kPa)
Min.
150 psi
(1030 kPa) Max.
I0300 - I1000 = 3/8"
Female Pipe Thread
I1200 - I1800 = 1/2"
Female Pipe Thread
Condenser Water
Drain
— —
1/2" Female Pipe
Thread
1/2" (13 mm)
minimum inside
diameter
Bin Drain — —
3/4" Female Pipe
Thread
3/4" (19 mm)
minimum inside
diameter
Large Capacity
Bin Drain
1" Female Pipe
Thread
1" (25 mm)
minimum inside
diameter
Min. = Minimum, Max. = Maximum
Loading ...
Loading ...
Loading ...