Loading ...
Loading ...
Loading ...
Maximum speed is reduced.
Corrective ActionProbable Cause
Instruct users not to push striding belt in either direction.
User is pushing striding belt. This occurs when the runner is running
faster than the striding belt will travel, with the result of the striding
belt being pushed with the runner’s feet.
User is stalling striding belt. This occurs with heavier users at lower
striding belt speeds. The striding belt will "stall" if the user is
traveling slower than the striding belt.
Replace belt and deck.
Striding belt/deck malfunctions. Thedeck laminate is worn through
or the underside of striding belt is glazed over (hard, glossy).
Plug treadmill into an appropriate circuit. Refer to Grounding
Instructions.
Note: In North America use a dedicated 20 amp circuit for
Commercial Units or a 15 amp circuit for Consumer Units.
Power source is insufficient.
Rubbing sound comes from underneath machine.
Corrective ActionProbable Cause
Power down theunit and disconnect AC power. Inspect underneath
striding belt and machine. Remove any debris or objects that may
cause interference with the treadmill.
Foreign objects may be stuck underneath the machine.
Display does not illuminate when machine is powered on.
Corrective ActionProbable Cause
Check all electrical connections for proper attachment.
• AC outlet and line cord
• Line cord at treadmill
• Power switch
• All console connections
• All lower electronics connections
• 12 VDC required for 50L console, 24 VDC required for 70T console
Contact Cybex International, Inc. Customer Support.
• No power.
• Loose connection(s).
• Incorrect console or power supply.
Unit resets randomly or pauses.
Corrective ActionProbable Cause
Plug treadmill into an appropriate circuit. Refer to Grounding
Instructions.
Note: In North America use a dedicated 20 amp circuit for
Commercial Units or a 15 amp circuit for Consumer Units.
Power source is insufficient.
Replace line cord.Damaged ground prong is on line cord.
Inspect power connection at electrical outlet and at machine for
proper contact.
Line cord improperly seated in electrical outlet.
Re-engage the emergency stop magnet.Emergency stop magnet is not engaged.
Move all possible obstructions off display console and handlebar.
Towel or other item may be making contact with stop switch while
user is running.
Page 16 of 31
Loading ...
Loading ...
Loading ...