Loading ...
Loading ...
Loading ...
Preventive Maintenance Schedule
BiannuallyMonthlyWeeklyItem
InspectCleanConsole Overlays
InspectCleanBottle Holders / Accessory Trays
InspectConsole Mounting Bolts
InspectHardware
InspectCleanFrame
InspectCleanPlastic Covers
Clean / InspectLifepulse Sensors
InspectStriding Belt Centered
Clean / InspectEmergency Stop Magnet
Vacuum / CleanCleanMotor Cover
InspectMotor Electronic Compartment
InspectDrive Belt
Inspect / AdjustLeg Levelers
InspectFront and Rear Rollers
InspectCleanSide Step Area
InspectCleanSide Hand Rails
InspectCleanErgo™ Front Handlebar
Troubleshooting the Treadmill
No power
Corrective ActionProbable Cause
Turn the switch to the ON position.ON / OFF switch is not in proper position.
Plug treadmill into an appropriate circuit. Refer to Grounding
Instructions.
Note: In North America use a dedicated 20 amp circuit for
Commercial Units or a 15 amp circuit for Consumer Units.
Using a voltmeter, verify power at outlet. If no power exists, reset
circuit breaker at panel.
Power source is insufficient.
Replace line cord. Contact Cybex International, Inc. Customer
Support.
Line cord is damaged.
Inspect power connections at wall outlet and at machineforproper
contact.
Line cord is improperly seated in socket.
Striding belt slips off- center.
Corrective ActionProbable Cause
Check levelers and level treadmill. Check striding belt & re-tension
as necessary. Refer to How to Adjust and Tension the Striding Belt.
Floor surface is uneven.
Page 15 of 31
Loading ...
Loading ...
Loading ...