Loading ...
Loading ...
Loading ...
Settings
111
Appliance parameters
Water intake
You can programme 6 options for the
water intake.
Options
– Cold water (factory default setting)
Uses mains water only.
– Hot water main wash
Hot water is used for the main wash
if a wash temperature over 30°C is
selected.
– Hot water MW + rinses
Hot water is used for the main wash
and for the rinses. Water
consumption is reduced by approx.
10% by rinsing with hot water.
– Soft water
An external water softener is used to
produce soft water. Soap based
detergents can be used and
limescale build-up in the washing
machine is prevented.
– Rain water
This setting is recommended if the
water hardness level of the alternative
water supply is lower than that of the
mains water supply. Detergent
savings can be made with this
setting.
– Well water
This setting is recommended in order
to prevent a build-up of limescale in
the washing machine if the water
hardness level of the alternative water
supply is higher than that of the
mains water supply.
Incorrect programming can lead to
damaged fabric (e.g. if the
programmed setting is for rain water
and the inlet hose is connected to
the hot water supply).
Make sure that the programmed
setting and the water connection are
correctly matched.
Observe the requirements for water
quality in “Installation and
connection – Water intake”.
Legal information
Open source licences
You can view information here.
Loading ...
Loading ...
Loading ...