Loading ...
Loading ...
Loading ...
5. Operating Your Grill
5.1 Select a proper location
Once you have assembled your new grill, nd a suitable location for use.
Note: The use and installation of this product must conform to local codes. In the absence of local codes, use the
National Fuel Gas Code: ANSI Z223.1/NFPA54, Storage and Handling of Liqueed Petroleum Gases, ANSI.NFPA 58
or Natural Gas and Propane Installation Code, CSA B149.1; Propane Storage and Handling, CSA B149.2.
m DANGER
1. Never use this outdoor grill inside any building, garage, shed or breezeway, or inside any boat, trailer or
recreational vehicle and/or boat, to prevent possible re and to prevent the possibility of carbon monoxide
poisoning or asphyxiation.
2. Always place your grill on a hard and level surface far away from combus-
tible materials and structures.
3. Do not use this grill under overhead combustible surface or covered area
(e.g., awnings, umbrellas, porches or gazeboes ). Keep all combustible
surfaces at least 24” (61cm) away.
4. Locate the grill away from any combustible and non-combustible mate-
rial or construction by at least 24 inches (61cm) from back and 24 inches
(61cm) from side.(See the diagram below)
5. Never store or use gasoline or other ammable or volatile substances in
the vicinity of this grill or in the vicinity of any other heat-generating appli-
ance, because of the danger of starting a re.
6. Do not obstructing the ow of combustion and ventilation air.
Step 3:
• Once Locking Bar is disengaged,
carefully lower the grill, allowing
the wheels to slide forward until
the Gill Body is in a at position.
To return grill to Cooking
Position, reverse above steps:
• Unlock Left and Right Securing Latches.
• Grab right side handle and pull up until Locking Bar engages with Handle Assembly.
• Lock Securing Latch on back right side.
Step 4:
• Lock Left and Right
Securing Latches to
the Lock Posts located
behind the grill.
Step 2:
• Stablize grill by placing foot on
right side Bottom Leg Assembly
Crossbar (Part L).
• Grab Right Side Handle and care-
fully lift Grill Body in upward motion
so Locking Bar disengages from
Handle Assembly.
Steps for Folding and Transport
10
11
Step 1:
• Ensure the lid is closed. Unlock
securing latch on back right side
of grill.
IMPORTANT: The Oven is designed to roll normally with pizza stone inside. Extreme angles or rough
terrain could dislodge and/or break the stone. Consider removing the stone from the oven for difcult
transit. NEVER remove stone while hot. Wait for it to cool.
Loading ...
Loading ...
Loading ...