Loading ...
Loading ...
Loading ...
Plumbing
118
Connecting the water supply
The water in the dishwasher is NOT safe to drink!
Do not reuse removable hose attachments. Use the hose sets
supplied with this dishwasher.
– The dishwasher's connection to the water supply system must be
in compliance with local code.
– The water quality should satisfy local drinking water requirements.
A high iron content can lead to external rust deposits on the wash
load and the dishwasher itself. A chloride concentration greater
than 100 mg/l in the process water significantly increases the risk of
corrosion for the wash load.
– In certain regions (e.g. mountainous areas), the typical water
composition can cause precipitates to form, which in turn requires
the use of softened water for the dishwasher.
– A device for preventing the return flow of water is not necessary, as
this dishwasher conforms to the applicable standards for the
protection of drinking water.
– The water pressure (flow pressure) must be equal to an
overpressure of at least 29psi / 200kPa (100 kPa = 1 bar). If the
water pressure (flow pressure) is less than 29psi / 200kPa, the
water intake time will automatically be extended. The maximum
allowable static pressure is 145psi / 1000kPa (overpressure). If the
water pressure lies outside the range of 29psi - 145psi (200kPa -
1000kPa), please contact Miele Service for instructions on how to
proceed.
– The standard version of this dishwasher is intended for connection
to the cold (blue marking) and hot (red marking) water supply with a
temperature of up to 149°F (65 °C). Connect the intake hoses to
the shutoff valves for the cold and hot water supply.
– If no hot water supply is available, the intake hose with the red
marking must also be connected to the cold water supply.
– Connect the intake hose for the steam condenser (without a water
protection device) to a cold water shutoff valve.
– An on-site shutoff valve with a 3/4" screw connection is required to
connect the dishwasher to the water supply. The valve should be
easily accessible, since the water supply should be shut off
whenever the dishwasher is not in use.
– The intake hose is an approx. 67" (1.7-m) long DN 10 pressure hose
with a 3/4" screw connection. A 59" (1.5m) flexible metal hose (test
pressure: 140 bar) is available as an extension. Do not remove the
filter from the screw connection.
Loading ...
Loading ...
Loading ...