Loading ...
Loading ...
Loading ...
Frequently asked questions
105
Unusual behavior of the dishwasher
Problem Possible cause and solution
The dishwasher fails to
react when buttons are
pressed. The display and
indicator lights remain
dark.
The dishwasher has turned itself off after the set Switch-off
time to save energy.
Press the button to turn the dishwasher on again.
The following fault
message is appears in the
display:
Salt container lid not closed
correctly
The salt reservoir cover is not properly closed.
Close the salt reservoir cover.
The dispenser cover
cannot be closed.
Detergent residue is blocking the latch.
Remove the detergent residue.
The inside of the door and/
or the interior walls are
wet after a program has
finished.
This is not a fault.
It is caused by the drying system.
The moisture will dissipate after a short while.
There is still water in the
wash cabinet at the end of
the program.
Before remedying the fault:
Turn the dishwasher off using the button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and care").
The drain pump or non-return valve is blocked.
Clean the drain pump or the non-return valve (see
"Frequently asked questions").
The drain hose is kinked.
Remove the kink.
The on-site drain trap is clogged.
Check and clean the drain trap.
Peak load cut-out
This is not a fault!
Your energy management system has detected a peak-
load in the energy supply. Some components in the
dishwasher stop operating for the duration of the peak-
load cut-out.
Loading ...
Loading ...
Loading ...