Loading ...
Loading ...
Loading ...
21
ELECTRIC DRYER ELECTRICAL CONNECTIONS ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY)(FOR U.S.A. ONLY)
F
F
WARNING
Fire Hazard
Use 10 gauge copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Direct Wire Connection
Remove Terminal Block Cover
A
B
E
D
C
3. Connect remaining wires with outer terminal block screws (F).
Tighten strain relief screws against power cord. Finally,
re-install terminal block cover and tighten hold-down screw.
Go to “Complete Installation” section
Connecting 3-Wire Connection: Power Supply Cord (cont.)
2. Connect white neutral wire (white or center) (D) to center
terminal block. Tighten screw.
D
Connection Options
Direct Wire
4-wire direct
Go to “Connecting 4-Wire Connection: Direct Wire” section.
1"
(25 mm)
5"
(127 mm)
3-wire direct
Go to “Connecting 3-Wire Connection: Direct Wire” section.
NOTE: If local codes do not permit connection of a cabinet-
ground conductor to neutral wire, go to “Connecting 3-Wire
Connection: Optional” section. This connection may be used with
either a power supply cord or a direct wire connection.
Before you start, disconnect power. Remove hold-down
screw (D) and terminal block cover (A).
A. Terminal block cover
B. External ground conductor screw
C. Center terminal block screw
D. Hold-down screw
E. Neutral ground wire
Remove hold-down screw and terminal block cover.
Loading ...
Loading ...
Loading ...