Loading ...
Loading ...
Loading ...
Troubleshooting en
49
Fault Cause Troubleshooting
Tableware is not dry. Tableware removed too
early or drying process not
yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes
after the programme has ended.
Rinse aid used has a limited
drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited ef-
fectiveness.
Appliance door does not
open automatically at the
end of the Eco 50° pro-
gramme
▶
Adjust the appliance door as de-
scribed in the installation instruc-
tions.
The door gap must be at least
70mm - 100mm.
Plastic tableware is not dry. Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
▶
No remedial action possible.
Cutlery is not dry. Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
1. Arrange the cutlery properly.
→"Arrange tableware", Page35
2. Arrange cutlery individually where
possible.
3. Avoid points of contact.
Appliance interior still wet
after wash cycle.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
No action required.
Remnants of food on table-
ware.
Tableware was placed too
close together.
1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Basket is overfilled. 1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Spray arm rotation is
blocked.
▶
Arrange tableware so that it does
not obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶
Clean the "Spray arms" →Page43.
Loading ...
Loading ...
Loading ...