Dji RS 2 User Manual

Loading ...

DJI RS 2 User Manual

To remove the lower quick-release plate, toggle the lever on the camera mounting plate

to the unlocked position and remove the lower quick-release plate while pressing the

safety lock on the mounting plate.

Safety Lock

RSS Camera Control Port

4. Connect the Camera Control Cable

Choose the proper camera control cable according to the camera type. Plug one

end of the cable into the camera and plug the other end into the RSS camera

control port of the gimbal as shown above.

Balancing

To obtain the best performance from DJI RS 2, proper balancing is essential. Proper

balance is critical for shots with DJI RS 2 where fast motion or acceleration is required

and also oers longer battery runtimes. There are three axes that need to be properly

balanced before powering on DJI RS 2 and setting up the software.

Before Balancing

1. The camera needs to be fully congured, with all accessories and cables connected,

before installing and balancing the camera on the gimbal. If the camera has a lens

cap, make sure to remove it before balancing.

2. Before balancing, make sure to power on the camera if using an optical zoom

lens and to select the focal length if using a varifocal lens. Make sure DJI RS 2 is

powered o or in sleep mode before balancing.

Balancing Steps

1. Balancing the Vertical Tilt

a. Unlock the tilt axis and loosen the mounting plate knob

b. Rotate the tilt axis so that the camera lens is pointing upward. Check to make

sure the camera is not top or bottom-heavy. If top-heavy, move the camera

backward

. If bottom-heavy, move the camera forward

c. Tighten the mounting plate knob while holding the camera upward. The vertical

tilt is balanced when the camera is steady while pointing upward.

Loading ...

Dji RS 2