Loading ...
Loading ...
Loading ...
14
English
Preparations
Setting the clock
After connecting the set to the power supply, set
the clock first.
Important!
To set clock in the Eco Power mode,
press and hold STANDBY-ON/ ECO
POWER B on the set for 3 seconds or
more to switch to normal standby mode
first before proceeding with the
procedures below.
1 Press CLOCK on the remote control to view
clock time.
➜ The display shows the set time.
➜ 00:00 displays by default if you have not set
the clock.
2 Press
CLOCK once again.
➜ The hours digits start flashing.
3 Hold down or press ALBUM/PRESET +/- on
the set repeatedly to set the hours.
4 Press CLOCK to confirm.
➜ The minutes digits start flashing
5 Hold down or press ALBUM/PRESET +/-on
the set repeatedly to set the minutes.
6 Press CLOCK to confirm.
– To exit without storing the clock setting press
9.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
Before using the remote control
1 Pull out the plastic protective sheet.
2 Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example CD, TUNER).
3 Then select the desired function (for example
ÉÅ , à , á).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote control
1 Press the slot on the battery compartment.
2 Pull out the battery compartment.
3 Replace a new battery and fully insert the
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
P001-P029_MCB279_05_Eng 2008.5.8, 16:2314
Loading ...
Loading ...
Loading ...