Loading ...
Loading ...
Loading ...
91
TROUBLESHOOTING
Cause Remedy See
When pressing the shutter button, the camera does not take a picture
The flash is not fully recharged or you
pressed the shutter button while the
camera is still processing the last shot.
Remove your finger from the shutter button and
press it again when the orange lamp has
stopped blinking.
P. 37
The card is full. Replace the card, erase unnecessary image
frames or download images to a PC, and then
erase all image frames in the card.
There is a problem with the card. Check the error message. P. 89
P. 46
P. 47
P. 81
The battery power has run out during
shooting or card writing.
Replace the batteries with new ones. P. 19
The remaining battery power is low. Replace the batteries. (If the orange lamp is
blinking to indicate that data is being written in
the card, wait until the blinking stops.)
P. 19
A write protect seal is attached to the
card or no card is inserted in the
camera.
Insert a new card or remove the write protect
seal.
P. 22
P. 24
The camera is in the Playback mode. Open the lens barrier. P. 30
The last-shot image is being written
to the card.
(The orange lamp blinks.)
Remove your finger from the shutter button, and
then wait until the orange lamp goes out before
retrying shooting.
The subject is too close. Set the camera to the Macro mode, and then
press the shutter button again.
P. 37
P. 60
Loading ...
Loading ...
Loading ...