Loading ...
Loading ...
Loading ...
TwK-88 & TwK-D8 Installation Manual
4
Signal Status LEDs
Located on top of the unit are two LEDs used to report the signal status of the
Twk
™
88 / D8. Separated by “Input” and “Output”, these LEDs may be referenced
during setup and normal use. Refer to the markings above the LEDs for specific
behavior condition.
5
Preset Toggle Button
Using the TüN
™
Software Interface, different tuning and/or function preferences
may be created and saved as presets. Located in a recess on top of the TwK
™
is the Preset Toggle button. Press the Preset Toggle button to select/advance
to the next enabled preset option. With each press, the JLid
™
status LED color
will change to reflect its assigned color as a visual confirmation. Pressing this
button operates the same as pressing the inner knob of the included DRC-200
Digital Remote Controller. Refer to the TwK
™
-TüN
™
Overview included with the
downloaded TüN
™
Software for detailed info about Preset functionality.
6
JLid
™
Port and DRC-200 Function
The JLid
™
Port is designed for connection of the DRC-200 Digital Remote
Controller. Equipped with two rotary level controls and push-button activation,
the DRC-200 adds the remote activation of the optional functions listed below.
Inner Rotary Control: By default, the inner rotary level control operates as a
Master Volume Control. The DRC-200 maintains linear frequency response at all
volume levels and delivers the best signal-to-noise performance for your audio
system. To use, leave the volume control of your source unit at the specific
volume position that was used during amplifier level setting and/or during
calibration of your FiX
™
OEM Integration DSP, if equipped. From now on, use
the DRC-200’s inner rotary control to adjust your audio system volume, leaving
the volume control at the level used for calibration/amplifier level setting.
You may continue to use the source unit’s tone, balance and fader controls, if
desired. Using the TüN
™
Software Interface, you may select which channels are
affected by the inner level control or reconfigure it to operate as a zone level
controller.
Outer Rotary Control: The outer rotary control is a secondary, assignable
level control that can be configured to operate as a subwoofer level control,
fader control or zone level control. Using the TüN
™
Software Interface, a
vast combination of control assignment and mixing combinations may be
programmed for each function type.
Push-Button Preset Toggle: Pressing the inner control knob of the DRC-200
operates the same as pressing the Preset Toggle button located on top of the
unit (see Preset Toggle Button above). Each press will select/advance to the
next enabled preset option. As a visual confirmation, the DRC-200’s multi-color
LED will also change to reflect the preset’s assigned color.
Loading ...
Loading ...
Loading ...