Loading ...
Loading ...
Loading ...
3. Hold the mounting plate against the selected installation location (wall or
ceiling) and mark the center of the holes with a pencil. To ensure aesthetic
alignment of the alarm, the “A” line on the mounting plate should be par-
allel with the hallway when ceiling mounting, or horizontal when wall
mounting (see figure 6).
4. Drill a hole through the pencil marks and use the enclosed screws and
anchors to secure the mounting plate (use 3/16”drill bit for anchor holes).
5. Install the alarm on the mounting bracket and rotate the alarm clockwise
until the alarm ratchets into place (this ratcheting function allows for aes-
thetic alignment). NOTE: The alarm will mount to the bracket in 4 positions
(every 90 degrees).
6. The green LED should blink once every 10 seconds.
7. Test the unit to ensure proper operation by pressing the Test Button. All
interconnected alarms should respond.
CAUTION: Due to the loudness of the alarm, always stand an arm’s
length away from the unit when testing.
Tamper Resist Features
This alarm has a tamper resist feature, which helps prevent someone from
r
emoving the unit from the mounting bracket. Activate the smoke alarm tamper
resist feature by breaking off the four posts in the square holes in the mounting
bracket (see figure 7A). When the posts are broken off, the tamper resist tab on
the base is allowed to engage the mounting bracket. Rotate the alarm onto the
mounting bracket until you hear the tamper resist tab snap into place, locking
the alarm. Using the tamper resist feature will help deter children and others
from removing the alarm from the bracket. NOTE: To remove the alarm when
the tamper resist tab is engaged, press down on the tamper resist tab, and
rotate the alarm off the bracket (see figure 7B).
FIGURE 9A
FIGURE 9B
Locations of Posts
Loading ...
Loading ...
Loading ...