Loading ...
Loading ...
Loading ...
Ethernet Port—Connect a wired network device to this port. This port supports PoE (Power over
Ethernet) with a PoE switch or PoE injector. LAPAC1200 can be powered on from an 802.3at
(PoE+) compliance source. Using CAT5e or better cable is highly recommended.
Note—When both PoE and AC power adapter are connected to access point, device will get
power from PoE as higher precedence.
Reset Button—Press and hold this button for less than 15 seconds to power cycle device. Press
and hold for longer than 15 seconds to reset the device to factory default settings.
Mounting Guide
To avoid overheating, do not install your access point if ambient temperatures exceed 104°F
(40°C). Install on a flat, stable surface, near the center of your wireless coverage area making
sure not to block vents on the sides of the device enclosure.
Wall Installation
1.
Position drilling layout template at the desired location.
2.
Drill four screw holes on the mounting surface. If your Ethernet cable is routed behind the
wall, mark Ethernet cable hole as well.
3.
Secure the mounting bracket on the wall with anchors and screws.
4.
If your Ethernet cable is routed behind the wall, cut or drill the Ethernet cable hole you
marked in Step 2. Feed the Ethernet cable through the hole.
5.
Connect the Ethernet cable and/or AC power adapter to your device.
6.
Slide the device into the bracket. Turn clockwise until it locks into place.
Ceiling Installation
1.
Select ceiling tile for mounting and remove tile.
2.
Position drilling layout template at the desired location.
3.
Drill four screw holes and Ethernet cable hole on the surface of ceiling tile.
4.
Place back plate on the opposite side of ceiling tile. Secure mounting bracket to the ceiling
tile with flathead screw and nut. Route the Ethernet cable through the Ethernet cable
hole.
5
Loading ...
Loading ...
Loading ...