Loading ...
Loading ...
Loading ...
12
3. Disconnect the Quick-Connect spray wand from the
trigger gun by twisting counter-clockwise until the 2
locking tabs of the spray wand can be removed from the
slot (Fig. 20).
4. To connect the foam cannon with the trigger gun,
press the locking tabs of the foam cannon into the slot of
the trigger gun, then twist counter-clockwise until the
2 parts are completely locked (Fig. 21).
5. Turn on the pressure washer. Pull the trigger to operate the
unit. The liquid detergent will automatically mix with water
and be discharged through the nozzle.
NOTE: The angle of the spray can be rotated 360º by
rotating the foam cannon nozzle. The foam volume can
be adjusted by rotating the adjustable cap, as indicated
below (Fig. 22).
mWARNING! Do not adjust the foam cannon while the
trigger is squeezed. Failure to do so could result in damage.
mCAUTION! Always test the detergent in an
inconspicuous area before use.
6. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface rst is not recommended as it
dilutes the detergent and reduces its cleaning ability.
7. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
mCAUTION! Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
8. When nished using the pressure washer, you must rst
drain and rinse the foam cannon bottle. Run the pressure
washer until all of the soap is drained from the foam
cannon bottle.
mCAUTION! Failure to follow these cleaning instructions
will cause the injection system to become clogged and
inoperable.
mIMPORTANT! NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage
the cleaning surface.
Using the Dual-Nozzle Rotating
Surface Cleaner
• Dual-nozzle rotating surface cleaner swivels up to 360° to
deep clean tough-to-reach areas with ease.
• Ideal for an endless array of cleaning projects – from porch
to patio, driveways and decks, boats, pavers, bricks,
BBQs and more!
1. Align the surface cleaner attachment with the top slots of
surface cleaner (Fig. 23).
Quick-Connect spray wand
Trigger gun
Fig. 20
Fig. 21
Trigger gun
Foam cannon
Locking tab
Fig. 22
Adjustable cap
Rotate spray angle 360º
Decrease
soap volume
Increase soap volume
Fig. 23
Surface cleaner
attachment
Surface
cleaner
Loading ...
Loading ...
Loading ...