Loading ...
Loading ...
Loading ...
Installation Instructions
Insttallation Instructions
6
Placing and leveling
Use the adjustable foot to bring the appliance in a uniform horizontal level in case there are minor abnormalities in flatness of the floor.
Make sure all foots are firm on the floor and there is no wobbling. Check this by trying to shake the appliance by holding the body. If
there is wobbling, it indicates that the foot needs adjustment or the floor is uneven and would need some civil work to make it flat.
2. Use a screwdriver to loosen 4 screws,
turn the B in the direction of arrow
till the distance between it and the
connector A is approx 5 mm.
A
B
Screwdriver
Attachment
Locking rod
Water inlet pipe
Moving
rod
1. Press and hold the slider down
and pull the adaptor of the water
inlet hose
3. Telescope the connector in the
water tap tightly, tighten the screw,
and turn nut B so as to engage A
and B
A
B
5. Screw down the other end of the
water inlet hose in clockwise
direction in the water inlet of the
washing machine
4. Press and hold the slider,
connect the water inlet
hose to the adapter
and let go of the
slider so as to
automatically
engage it.
Note:
After being connected, if water
leaks, just repeat the aforesaid
steps to connect the water inlet
hose again.
Water inlet hose should be
connected to an ordinary
tap.
Water Inlet Hose & Drain Installation
Adjustable foot
Base foam
Screw in
Screw out
Fixing frame
NOTE: If the washing machine is not placed on a flat surface. It may result in a high vibration during the course of the wash
NOTE: 1. After installation, do not start the washing machine in a hurry. First open the tap to let the water pass into the water inlet
hose and ensure there is no leakage through the connectors on both the ends. When the pressure is too high, please
shut the tap a little to avoid water leakage.
2. Put the outlet of the drain hose in a nearby drainage permanently, which can save the trouble of connecting the hose
before every use. If the drainage is far away from the washing machine, it can be solved by putting an extended hose
at the end.
3. Drain faults will occur when the drain hose is blocked.
The washing machine employs alternating current with a rated frequency. The method of connection of the socket is shown
in the figure below:
Notice: The socket and the grounding wire must be installed by an electrician to prevent incorrect
installation or use of the socket, and to guarantee safety.
The power wire of the washing machine employs Y connection and the replacement of the
power wire should be carried out by professionals.
Power Connection and Grounding
Installation Important!
Insttallation Important
8
• For electrical connection carefully, follow the instructions given in this manual. Unpack the appliance and check if there are
damages on it.
• Do not connect the appliance if it is damaged. Report possible damages immediately to the place you bought it. In this case
retain packing.
• It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor.
• Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation, follow
the instructions relevant to installation.
• Wherever possible the back of the product should not be too close to a wall to avoid touching or catching warm parts
(compressor, condenser) to prevent the risk of a fire, follow the instructions relevant to installation.
• The appliance must not be locate close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
Service
Service
• Any electrical work required to do the servicing of the appliance should be carried out by qualified electrician or competent
person.
• This product must be serviced by an authorized Service Center, and only genuine spare parts must be used.
1. If the appliance is Frost Free.
2. If the appliance contains freezer compartment.
Loading ...
Loading ...
Loading ...