Loading ...
Loading ...
Loading ...
19
CAUTION
BEFORE CUTTING HOLE IN CABINET FOR
DUCTWORK, check for interference with fl oor
joists, wall studs, electrical wiring, or plumbing.
• Refer to Ductwork Confi gurations in the Planning section of this
document.
• Cut hole in cabinet as well as holes in wall or fl oor as necessary.
• Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork, elbows and transitions as previously
planned. Tape all ductwork connections to make them secure and
air tight.
• Connect ductwork (and transition, if required) to downdraft.
Place retaining washer on left trim cap (C). Insert hinge pin into slot of the
fl ip door. Position left trim cap and fl ip door. Align trim caps and complete
assembly by hand tightening trim cap screws.
Note: Make sure trim sits at on countertop surface, is ush with top door,
and has 1/16” GAP between trim and top door.
Installation
Position right trim cap (D) and start screw. Do not fully tighten screw.
Place retaining washer on right trim cap. Insert hinge pin into slot of the
fl ip door.
Note: Make sure trim: sits at on countertop surface, is ush with top door,
has 1/16” GAP between trim and top door, and wiring is not pinched.
Installing Finish Trim (continued)
Installing Ductwork
Door Trim
1/16" Gap1/16" Gap
Washer
TOP VIEW
Flush
3
2
4
1
D
D
Retaining
Washer
Retaining
Washer
D
16
TOP VIEW
Flush
2
3
1
C
Retaining
Washer
Retaining
Washer
C
C
DoorTrim
1/16" Gap1/16" Gap
Washer
2
17
Installing Finish Trim
CAUTION
Only connect or disconnect UP BUTTON CABLE
with main power off for at least 60 seconds.
Insert wiring harness from right upper button (D) into opening in side of
downdraft (B). Insert upper button (D) wiring harness into receptacle at
lower right side of downdraft (B).
15
1
B
D
2
Loading ...
Loading ...
Loading ...