Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 319
REAR TAIL / STOP, TURN SIGNAL AND BACKUP
LAMPS
See the following steps to replace:
1. Remove the two screws that pass through the
bed sheet metal.
Tail Lamp Screw Locations
2. Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the
two plastic snap post retainers in the outer box
side panel.
Pulling Out The Tail Lamp
3. Disconnect the wiring harness connectors
from the bulb socket.
4. Rotate the bulb socket counterclockwise a
quarter turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
6. Reverse the procedure to install the bulb and
housing.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
8
22_DS_OM_EN_USC_t.book Page 319
Loading ...
Loading ...
Loading ...