Loading ...
Loading ...
Loading ...
150 MULTIMEDIA
UCONNECT SETTINGS
The Uconnect system uses a combination of
buttons on the touchscreen and buttons on the
faceplate located on the center of the instrument
panel. These buttons allow you to access and
change the Customer Programmable Features.
Many features can vary by vehicle.
Buttons on the faceplate are located below and/or
beside the Uconnect system in the center of the
instrument panel. In addition, there is a SCROLL/
ENTER control knob located on the right side. Turn
the control knob to scroll through menus and
change settings. Push the center of the control
knob one or more times to select or change a
setting.
Your Uconnect system may also have SCREEN OFF
and MUTE buttons on the faceplate.
Push the SCREEN OFF button on the faceplate to
turn off the Uconnect screen. Push the button
again or tap the screen to turn the screen on.
Press the Back Arrow button to exit out of a Menu
or certain option on the Uconnect system.
For the Uconnect 5 system, push and hold the
Power button on the radio’s faceplate for a
minimum of 15 seconds to reset the radio.
CUSTOMER PROGRAMMABLE FEATURES
Uconnect 4/4C/4C NAV With 8.4-inch Display
Touchscreen And Faceplate Buttons
For the Uconnect 3 With 5-inch Display, the
Uconnect 4C NAV With 8.4-inch Display, and the
Uconnect 5 With 8.4-inch Display
For the Uconnect 3, push the SETTINGS button on
the side of the faceplate to display the menu
setting screen. In this mode, the Uconnect system
allows you to access programmable features.
For the Uconnect 4C NAV, press the Apps
button, then press the Settings button on the
touchscreen to display the menu setting screen. In
this mode, the Uconnect system allows you to
access programmable features.
For Uconnect 5, press the Vehicle button on the
touchscreen, then press the Settings tab at the top
of the touchscreen. In this menu, the Uconnect
system allows you to access all of the available
programmable features.
NOTE:
Depending on the vehicle’s options, feature
settings may vary.
All settings should be changed with the ignition
in the ON/RUN position.
When making a selection, only press one button at
a time to enter the desired menu. Once in the
desired menu, press and release the preferred
setting option until a check mark appears next to
the setting, showing that setting has been
selected. Once the setting is complete, press the X
button on the touchscreen to close out of the
settings screen. Pressing the Up or Down Arrow
button on the right side of the screen will allow you
to toggle up or down through the available settings.
1 — Uconnect Buttons On The Touchscreen
2 — Uconnect Buttons On The Faceplate
22_DS_OM_EN_USC_t.book Page 150
Loading ...
Loading ...
Loading ...