Loading ...
Loading ...
Loading ...
30
EN
4. Loosen the CO₂ bottle sheath (Show as gure 15), insert a 16 gram CO₂ cartridge
in the sheath (Figure 16), and screw the sheath tightly until you will hear a
“Click”(Figure 17), which indicates that the cartridge seal has been pierced and the
CO₂ gas can ow into the keg freely. Make us the bottle sheath is xed tightly to
avoid the CO₂ leakage. Then put CO₂ bottle sheath into the top cover.
Note: Turn off the CO₂ knob when cooling the beer, turn off when the beer ow
is paused, turn off when changing the CO₂ cartridge. If the beer cannot be
tapped out (there is still beer in the keg), or beer foams are not enough, turn the
knob to „+“ position for 5 seconds then turn it off again.
5. Close the top cover of the beer cooler; When pouring out the beer, the turn the
knob on the top cover to “+” position to release the CO₂, and turn it to “-“position
when pause or stop pouring beer to close the CO₂. Please refer to the notice label
on the top cover.
6. Turn on the power switch to “I” position to power on the beer cooler. (While
“0”position is to power it off). Note: Please make sure your hands are dry
when you operate the beer cooler, to avoid electric shock.
7. It will take 19-21 hours to cool the beer to 0-4 °C at 22-24 °C ambient
temperature. And it can keep the temperature as set and displayed on the LED.
(The LED will display the real temperature of the beer). We do, however, suggest
that you initially cool your beer keg for at least 12 hours in your refrigerator before
placing it into the beer cooler, especially when the ambient temperature is higher
than 25°C.
Regualtor
Housing
Cartridge holder
CO₂ cartridge
Loading ...
Loading ...
Loading ...