Loading ...
Loading ...
Loading ...
4
l The power cord supplied with the heater has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter MUST be used. The adapter
MUST be properly grounded to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
l SAVE THESE INSTRUCTIONS!
PREPARATION
This insert has a front panel made of GLASS! ALWAYS use extreme caution when
handling glass. Failure to do so could result in personal injury or property damage.
NOTE: Remove all parts and hardware from the carton and place them on a clean, soft, dry surface.
Check the parts list to make sure nothing is missing. Dispose of packaging materials properly. Please
recycle whenever possible.
Tools required for installation: Phillips screwdriver (Not included)
ELECTRIC INSERT: PARTS & HARDWARE
Item
Description
Qty
B
A The remote control operates with one 3V
CR2032 Lithium Cell Battery (included).
A
Fireplace Insert
1
B
Remote Control
1
C
Screws (4*8)
8
D
Screws (4*12)
8
E
L-shaped plate
4
C D E
Remote Control Set-up
l Fig. 1: Remove the plastic sheet from the end of the remote control to allow the battery to
touch the electrical contacts. If the sheet is not removed, the remote control will not work.
l Fig. 2: To install or replace the battery, press the button to allow the battery case to slide out.
Position the battery according the drawing, and slide the case back in to the remote.
Loading ...
Loading ...
Loading ...