GE Café™ CSB48YP2RS1 48" Smart Built-In Side-by-Side Refrigerator with Dispenser

Owner's Manual & Installation Instructions - Page 28

For CSB48YP2RS1. Also, The document are for others GE - General Electric models: CSB42, CSB48

PDF File Manual, 113 pages, Read Online | Download pdf file

CSB48YP2RS1 photo
Loading ...
Loading ...
Loading ...
49-1000361 Rev. 7 27
INSTALLATION INSTRUCTIONS
Installation Instructions
STEP 3 INSTALL WATER LINE
• A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 p.s.i. (275-827 kPa).
5RXWH´2'FRSSHURU6PDUW&RQQHFW
plastic
tubing between house cold water line and the water
connection location.
• The tubing should
be long enough to
extend to the front of
the refrigerator. Allow
enough tubing to
accommodate the bend
leading into the water line connection.
NOTE: The only Café approved plastic tubing is
supplied in the SmartConnect
Refrigerator Tubing
kits. Do not use any other plastic water supply line
because the line is under pressure at all times. Other
types of plastic may crack or rupture with age and
cause water damage to your home.
SmartConnect
5HIULJHUDWRU7XELQJ.LWVDUHDYDLODEOH
in the following lengths:
2’ (.6 m) WX08X10002
8’ (2.4 m) WX08X10006
15’ (4.6 m) WX08X10015
25’ (7.6 m) WX08X10025
STEP 1 REMOVE PACKAGING
WARNING
Tip Over Hazard.
The refrigerator is much heavier at the top than at the
bottom—be careful when moving. When using a hand
truck, handle from the side only.
AVERTISSEMENT
Risque de
basculement La partie supérieure du réfrigérateur
est beaucoup plus lourde que sa partie inférieure – Soyez
prudent lorsque vous le déplacez. Si vous utilisez un chariot
PDQXHOPDQLSXOH]OHUpIULJpUDWHXUSDUOHF{WpVHXOHPHQW
ADVERTENCIA
Riesgo de
Caídas. El refrigerador es mucho más pesado en la
parte superior que en la parte inferior – tenga cuidado al
moverlo. Al usar un carro manual, sostenga el mismo del
lateral únicamente.
• Carefully cut banding at the top and bottom, remove
the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE: IT IS NOT NECESSARY TO LAY THE
&$%,1(7'2:1,125'(5725(029(7+(6.,'
• The unit is secured to the skid with 4 slotted tie-
GRZQVWUDSV5HPRYHWKHVL[´EROWVIURPWKH
base channels in the tie-downs.
5HPRYHWKHVL[´EROWVVHFXULQJWKHVWUDSVWR
the skid.
NOTE: '2127$77(0377252//81,72))6.,'
• The support blocks on the bottom of the refrigeration
case must be removed
before the refrigerator
is taken off the skid
or damage will occur.
Carefully tilt the refrigerator
and slide the blocks out
from beneath.
Remove the toekick and set
aside for final installation.
• Lift the refrigerator off the
skid with an appliance
dolly. Handle from the
sides.
Remove
Tie Downs
Toekick
Floor
Cold Water Line
STEP 2 MOVE THE
REFRIGERATOR INTO THE HOUSE
• Re-use the corner posts from the packaging to
protect stainless steel models. Run the appliance
dolly straps over the posts and under the handles.
• Leave the protective film on the refrigerator until
installation is complete. IMPORTANT: Never lift the
refrigerator by the handle or push against the grille
SDQHOWKLVFRXOGFDXVHGDPDJHRUPLVDOLJQPHQW
• Avoid laying the unit on its back or side to prevent
sealed system restrictions.
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
AVERTISSEMENT
Raccordez l’appareil à
une alimentation d’eau potable seulement. Une
alimentation d’eau froide est requise pour faire
fonctionner la machine à glaçons et le pichet à
remplissage automatique. La pression d’eau doit se
situer entre 40 et 120 psi. (275 à 827 kPa).
AVERTISSEMENT
RISQUE DE DÉCHARGE
ÉLECTRIQUE
Fixez le collier de serrage dans le trou présent
seulement. NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento
de la máquina de hielos automática y de la jarra de
llenado automático. La presión del agua deberá estar
entre 40 y 120 p.s.i. (275 – 827 kPa).
ADVERTENCIA
PELIGRO DE
DESCARGA ELÉCTRICA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
Loading ...
Loading ...
Loading ...