Loading ...
Loading ...
Loading ...
ID number input success
After the last ID number is inputted, the ignition switch
ring and Honda SMART Key Indicator will flash every 2
seconds until the EM mode coupler is removed.
Be sure to remove the EM mode coupler and return
the blue dummy coupler. The buzzer rings 2 times
when the EM mode coupler is removed. The ignition
switch is then unlocked.
Reinstall the parts in reverse order of removal and
turn the ignition switch to the ON position within 6
minutes. You can start the engine.
To lock the ignition switch, turn the ignition switch to
the OFF, or (Lock) position, and press and hold
the ignition switch for 2 seconds. The buzzer rings 1
time. The ignition switch also locks automatically
when the ignition switch has been in the OFF, or
(Lock) position for about 6 minutes after the ID
number is successfully inputted.
When the ignition switch is locked, the ignition switch
ring goes off.
To unlock the ignition switch again, repeat the
procedure for unlocking the ignition switch.
ID number input failure
After the last ID number is inputted, the ignition
switch ring and Honda SMART Key Indicator will flash
every second until the EM mode coupler is removed,
and the ignition switch cannot be unlocked.
Pull out the EM mode coupler and reconnect it to the
EM mode connector. Follow the procedure again.
2 P. 109
ID number input cancel
Pull out the EM mode coupler from the EM mode
connector.
Also, if you make a mistake while inputting the ID
number, remove the EM mode coupler from the EM
mode connector, connect it to the EM mode
connector again, and then re-input the ID number
from the beginning.
●
Store the removed EM mode coupler on the
battery cover at all times.
20181019183311_31K0GA000_enu_BOOK Page 114 Friday, October 19 2018 18:39:26 JST
Unlock the Ignition Switch in an Emergency
Troubleshooting
111
Loading ...
Loading ...
Loading ...