Loading ...
Loading ...
Loading ...
11
A combination of pipe fittings must be used to connect the dryer
to the existing gas line. Shown is a recommended connection.
Your connection may be different, according to the supply line
type, size, and location.
A
B
C
D
A.
3
/8" flexible gas connector
B.
3
/8" dryer pipe
C.
3
/8" to
3
/8" pipe elbow
D.
3
/8" pipe-to-flare adapter fitting
3. Open the shutoff valve in the supply line. The valve is open when
the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
A
B
4. Test all connections by brushing on an approved noncorrosive
leak-detection solution. Bubbles will show a leak. Correct any leak
found.
Connect Vent
1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure the vent is clean.
The dryer vent must fit over the dryer exhaust outlet and inside the
exhaust hood. Check that the vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2. Mo
ve dryer into its final location. Do not crush or kink vent.
3. Check that ther
e are no kinks in the flexible gas line.
4. Once the exhaust vent connection is made, remove the corner
posts and cardboard.
Connect Inlet Hose
The dryer must be connected to the cold water faucet using the new
inlet hoses. Do not use old hoses.
1. T
urn cold water faucet off and remove washer inlet hose.
2. Remove old rubber washer fr
om inlet hose and replace with new
rubber washer provided. If space permits, attach the brass female
end of the “Y” connector to the cold water faucet.
NOTE:
If “Y” connector can be attached directly to cold water
faucet, go to Step 6. If “Y” connector cannot be attached
directly to the cold water faucet, the short hose must be used.
Continue with Step 3.
3. A
ttach short hose to cold water faucet. Screw on coupling by
hand until it is seated on faucet.
4. Using
pliers, tighten the couplings with an additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
5. Attach “Y” connector
to brass male end of small hose. Screw on
coupling by hand until it is seated on connector.
6. One end of the long hose has a wire mesh strainer inside the
coupling. Attach this end to the “Y” connector.
7. Attach washer cold inlet hose to ot
her end of “Y” connector.
Screw on coupling by hand until it is seated on connector.
8. Using
pliers, tighten the couplings with an additional two-thirds
turn.
A
A. Inlet to cold water
NOTE: Do not overtighten. Damage to the coupling can result.
9. At
tach other end of long hose to fill valve at bottom of dryer back
panel. Screw on coupling by hand until it is seated on fill valve
connector.
10. Using
pliers, tighten the coupling with an additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
11. Ch
eck that the water faucets are on.
12. Ch
eck for leaks around “Y” connector, faucet, and hoses.
Loading ...
Loading ...
Loading ...