Loading ...
Loading ...
Loading ...
5
REMOTE CONTROL
Use a CR025 3V battery for this remote control.
1. Power ON/OFF
2. Heating element adjustment. Low is 700W, and HIGH is 1400W. Heat will start within 10
seconds.
3. Temperature adjustment
4. Timer – this can be set for anywhere between 1 and 9 hours. Press button once for each
hour increment you desire.
5. Adjust the brightness of the flame effect
GLASS INSTRUCTIONS
1. Under no circumstances should this product be operated with a broken or chipped glass
panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass. Make sure the glass is cool to the touch.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer
should be done by qualified/authorized personnel only.
MAINTENANCE OF MOTORS
1. Always disconnect the unit from the main power supply and allow it to cool before any
servicing operation.
2. The motors used on the fan heater and flame blower are pre-lubricated for extended bearing
life and require no further lubrication. However, periodic cleaning/vacuuming of the unit
around the air intake and exhaust, as well as the fan heater, is recommended. For heavy
blows alternating cold and warm air, check the fan for free movement and for debris
restricting air flow. If the fan does not move freely, the unit needs to be turned off and the fan
replaced in order to prevent further damage of the unit.
BATTERY REPLACEMENT
Please dispose of the remote’s used battery per municipal or provincial/state law.
CARE AND CLEANING
Loading ...
Loading ...
Loading ...