Sun Joe 24V-XFP5-LTE 24-Volt iON+ Cordless 5.0-GPM Transfer Pump Kit

OPERATOR’S MANUAL - Page 12

For 24V-XFP5-LTE.

PDF File Manual, 20 pages, Read Online | Download pdf file

24V-XFP5-LTE photo
Loading ...
Loading ...
Loading ...
12
1. Switch o the pump, remove the battery from the battery
compartment, and disconnect all hoses.
2. Using a screwdriver, remove the 5 screws that used to x
the impeller cover plate (Fig. 10).
3. Remove the worn impeller and O-ring (Fig. 11). .
4. Replace with the new impeller and O-ring. When
assembling the impeller, make sure to align the axle with
the middle hole of the impeller, and push the impeller into
the pump as far as it will go.
5. Make sure the O-ring is properly seated and replace
impeller cover plate. Secure with the original 5 screws.
6. Secure the hoses and insert the battery, turn on the pump
to make sure there's no leaking from the impeller cover
plate.
Proper Care for Battery + Charger
mWARNING! To reduce the risk of injury, always unplug
the charger and disconnect the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
ow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only a soft, clean and dry brush to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never use
ammable or combustible solvents around battery packs,
battery chargers or tools.
4. The iON+ 24VCHRG-AC lithium-ion battery charger has
no serviceable parts.
Storage
Store the pump indoors in a dry, locked-up place out of
the reach of children, with the battery pack disconnected.
Disconnect and drain all hoses. Keep away from corrosive
agents such as garden chemicals and de-icing salt.
Battery + Charger O-Season Storage
1. Do not expose your battery pack or charger to water,
rain or allow them to get wet. This could permanently
damage the charger and the battery pack. Do not use oil
or solvents to clean or lubricate your battery pack as the
plastic casing can become brittle and crack, causing a
serious risk of injury.
2. Store the battery pack and charger at room temperature
away from moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
pack types, permanent capacity loss can result if the pack
is stored for long periods of time at high temperatures
(over 120ºF/49ºC).
3. iON+ 24VBAT-LTE lithium-ion battery packs maintain
their charge during storage longer than other battery
pack types. As a general practice, it is best to unplug the
battery charger and disconnect the battery pack when
they are not in use. Recharge the battery pack every 6
months to 50% capacity (2 lights on) during o-season
storage to maintain optimal battery performance.
Fig. 10
Impeller cover
plate
Screws
Fig. 11
Impeller
O-ring
Loading ...
Loading ...
Loading ...