Loading ...
Loading ...
Loading ...
4
13
14
SECTION IV (continued)
12. Disconnect range power supply, then
install light bulb under shelf by inserting pins on bulb
into receptacles at sides of shelf.
13. Install glass light lens with painted side
toward the back wall under the shelf. Start the leading
edge of the glass into the “Z” shaped section under the
shelf and rotate bottom edge of glass up against the
backsplash as shown in figure (13). Install glass lens
retainer (stainless steel) up against bottom of glass using
a 3 truss-head phillips screws as shown in figure (14).
14. Check oper ation of light by pressing
switch on front of shelf.
TO CLEAN BACKSPLASH
Wipe with soapy cloth or nonabrasive cleanser, such
as Luneta (Jenn-Air Model A912, Part No. 712191).
Rinse, buff with soft cloth, polish with glass cleaner
if necessary.
NOTE: DO NOT use abrasive cleansers or Scotch
Brite pads.
TO REPLACE BULB
Disconnect range power supply before installing
bulb or servicing backsplash.
Remove glass light lens: Carefully remove the
glass lens retainer and glass light lens by removing
the 3 screws using a phillips screwdriver.
NOTE: The glass light lens is separate from the
light lens retainer. The two pieces will dr op down
into your hands at the same time as the last screw
is removed.
Fluorescent bulb: Using both hands, rotate bottom
of fluorescent tube a quarter turn towards
backsplash. Replace with a similar size 18 watt --
28″ Cool White fluorescent bulb by first inserting
bulb prongs into sockets and then rotate bottom of
fluorescent tube towards you.
Replace glass light lens: Place the glass with painted
side toward the back wall under the shelf. Start the
leading edge of the glass into the “Z” shaped section
under the shelf and rotate bottom edge of glass up
against the backsplash. Install the glass lens retainer
(stainless steel) up against the glass. Using a phillips
screwdriver add the 3 screws.
Loading ...
Loading ...
Loading ...