Loading ...
2
SECTION II
WIRE HARNESS CONNECTION
41. WARNING: RANGE MUST BE
DISCONNECTED FROM POWER SUPPLY
BEFORE ATTEMPTING INSTALLATION. DO NOT
DISTURB ANY INTERNAL WIRING AND SUPPLY
WIRING (WHERE APPLICABLE).
42. REMOVE WIRE COVER: Remove (2)
screwsretaining wire cover to the range structure as shown
in figure (5).
43. REMOVE KNOCKOUT: Remove
knockout with a screwdriver and pliers by bending until
the retaining tabs break. Insert Harness Plug included with
backsplash into knockout hole from underneath side by
pushing up until it snaps into place as shown in figur e
(6).
44. Install terminals from harness to range
supply terminal block as shown in figure (7). Use nuts
supplied. Connect black wire to the terminal with black
wires.Connect white wire to the terminal with whitewires.
45. Replace wire cover on range structure.
Insert (2) screws and tighten.
5
6
7
Loading ...
Loading ...
Loading ...