Loading ...
Loading ...
Loading ...
BODYCRAFT provides a Lube Indicator on your console indicating when the running belt
lubrication is required. The indicator will light when cleaning & lubrication is needed. If
you see this indicator pop up on the screen, follow the lubrication instruction below or call a
certified BODYCRAFT service provider.
Please be sure your treadmill is powered off, before performing this maintenance.
STEP 1: Vacuum under treadmill and clean area between the running belt and side rails.
Then continue with cleaning the area between the deck and the running belt as described
from the Preventive Maintenance page.
STEP 2: Take the BODYCRAFT 100% Pure Silicone Oil Bottle and cut the tip off. Then lift the running
belt up and away from the deck as far as you can on the left side of the treadmill. Point the silicone bottle
nozzle towards the center of the running deck. Lay a small bead of silicone on the deck, while moving
down the deck continue holding the belt up as you go. Stop the lube about 2” from the side of the
running belt edge.
Repeat the process on the right side of the belt. See below drawing
STEP 3: After Step 2, turn the power back on.
● For LCD console, press STOP button for a few seconds until the Lube indicator light turns off.
● For TFT (SmartTouch) console, please follow on screen instruction to reset the Lube timer.
STEP 4: Use QUICK START and walk on your treadmill at a low to moderate speed for 5 minutes to
evenly distribute the silicone lubricant.
● Lift up the running belt up and away from
the deck as far as you can and add
about 10 ml of silicone oil towards the
center of the running deck from on the
left side.
● Do the same thing for the right side.
Lubricant is necessary when the deck becomes dry to
maintain your treadmill’s warranty and keep in a good
working condition.
To purchase lube bottle go to www.bodycraft.com/treadlube.html
or email [email protected]
36
● Resetting the Lube Indicator: AFTER the lubrication procedure is complete:
- 9” LCD: Press & hold “STOP” key during idle mode for a few seconds to turn
the LUBE icon off for the.
- 16” & 10” Touch Screen: Follow the Reset prompts on the console.
Lubrication to the deck is very important to your treadmill.
Your treadmill is equipped with a pre-lubricated low friction, reversible deck, that reduces the frictional
forces working against the treadmill’s drive motor. Over time, belt and deck wear due to regular use can
increase friction forces and make your treadmill’s motor work harder. This is true for any motor driven
mechanical device. Keeping friction to a minimum helps extend component life. Additionally, nonuse of
the treadmill for an extended period can lead to a dry deck. If the treadmill belt slows down very quickly
after you have completed your workout, it may lack adequate silicone.
WHY LUBRICATE THE BELT/DECK AREA?
Caution: Do not drip any lubricate on top of the running belt. Completely clean top surface
with a mild soap cleaner if needed. Check top running surface is 100% dry before using treadmill.
How to lube
video on YouTube
NOTE: If you lubricate too much, the running belt
may slip or liquid may flow out from the machine.
Only use 1/3 of bottle (1 oz) per lubrication.
Lubricating the Running Belt / Deck Area - T1000, T800 & T400
Loading ...
Loading ...
Loading ...