Loading ...
Loading ...
Loading ...
Product Assembly
22
STEP 15 – Console Wiring to the Dashboard Assembly.
Please Confirm All Bolts are Tightened at this time!
Install Power Cord into power socket
Wire #1
Wire #2
Wire #3
22
a. Connect the following cables from the Console (099) to the Dashboard Assembly (077-ASM):
i. 1st Cable - Break-Out Board to Console - Lower (#170 w/9pin) <<<< --- >>> Cable -
Main Console (#220 w/9pin)
ii. 2nd Cable - Break-Out Board to Console - Lower (#107 w/2pin) <<<< --- >>> Cable -
Power Console (#221 w/2pin)
NOTE: 2nd Cable is ONLY USED with Touch 16” & 10”. NOT to be used with the 9” LCD consoles.
iii. 3rd Cable/Wire Grounding Cable (#187 w/ 1pin) <<< --- >>> Grounding Cable Console
(#207 w/1pin)
Fig. 13
b. After all cables are connected, confirm they are fully
locked together. Then GENTLY slide the console
onto the U-Shaped tubes without damaging any
cable or connections. See pic on Fig. 13.
NOTE: Easier & SAFER for two people to perform this
task. Pinched or severed cables during assembly is
not covered under warranty.
WRONG from SRS below
Loading ...
Loading ...
Loading ...