Loading ...
Loading ...
Loading ...
7
Locking And Unlocking Your Wafe Maker
Your Wafe Maker is unlocked only when the Control Knob is facing up. You can only open the Wafe
Maker in the unlocked position.
Tips For Perfectly Baked Wafes
1. Stir your wafe batter only until large chunks of dry ingredients are dissolved. Over mixing the
wafe batter can cause the wafes to be hard.
2. Set the Control Knob to your desired setting. The higher your setting, the darker your wafes will
be. The color and crispness of the wafes also depends on the batter used. Experiment with the
setting and different wafe batters to determine your ideal Wafe Maker settings
3. The exact amount of batter needed to make perfect full-sized wafes depends on the type and
consistency of the batter. Use the same ladle or measuring cup each time to determine how much
batter you need to ll the lower plate fully so as to cover the peaks in the plate.
4. When making softer variety of wafes, once they are baked, make sure to cut the wafes into
halves or in 4 quarters and support them with a spatula at the bottom so it is easier to take them
out from the plates, since softer wafes can break easily.
5. When making large batches to serve at once, you can keep the wafes fresh & crisp by placing
them in a preheated oven at 200°F. Take them out using oven mitts when you are ready to serve.
6. To avoid wafes with a moist base, kept the wafes on a wire cooling rack. This will retain the
crispness of the wafes.
7. You can reheat your wafes in the wafe maker. Pre-heat the wafe maker on low setting. Once
preheated, place the wafes on the lower plate so they t the grooves correctly, then close the
wafe maker and heat for 1 to 2 minutes, checking every 30 seconds to avoid burning.
8. You can also freeze your wafes to eat later. After the freshly baked wafes have cooled completely,
pack them in a covered container or plastic freezer bag. Make sure to separate the wafes with a
sheet of wax paper between each wafe. To reheat the frozen wafes, place in a pre-heated oven,
toaster oven or toaster until they are hot.
Cleaning and Maintenance
1. Always turn off the appliance, unplug it, and allow it to cool down before cleaning.
2. You can easily remove any excess oils or crumbs without disassembling the appliance.
3. Never submerge the appliance in water or place it in the dishwasher.
4. Use only plastic or wooden utensils on the heating plates. Metal may damage the plates.
5. Use a soft cloth on the heating plates and occasionally a metal polish intended for stainless steel on
the outer housing. Never use abrasive scouring pads or steel wool.
6. If there is hardened batter on the plates, pour a little oil and let it sit for about 5-7 minutes.
You can then wipe clean with a paper towel.
7. Do not use the Wafe Maker for anything other than making wafes.
SO-312384_14446, 13591_BELLA_SS Rotating WM_WM USA_IM_R6.indd 7 2019-07-03 9:16 AM
Loading ...
Loading ...
Loading ...