Loading ...
Loading ...
Loading ...
ASSEMBLY
1 Fit the handlebar post onto the
handlebars. Make sure the letters on
the post will be upright when the
handlebar is right-side-up.
2 Add two at washers and two M8×12
round head screws to the front of the
handlebar base. Screw them in with a
5mm Allen wrench.
3 Add two at washers and two M8×10
round head screws to the sides of the
handlebar base. Screw them in with the
5mm Allen wrench.
4 Loosen the L-handle at the front of the
bike frame and slide the handlebar post
into the head tube.
5 Add an M5×15 Phillips head screw to
the hole at the end of the handlebar
post. Screw it in using a Phillips
head screwdriver.
6 Raise the handlebars to seat height and
tighten the L-handle.
7 Take four M5x12 round head screws
and add one at washer and one spring
washer to each.
8 Secure each weight holder to the seat
slider using two screw-and-washer sets
and a 4mm Allen wrench.
9 Rest the bike frame on the weight
holders and back foot.
1-3
5
4
6
BIKE ASSEMBLY CONTINUED
7-8 9
24
Loading ...
Loading ...
Loading ...