Bose L1 Owner’s Guide

Loading ...

PERATING INSTRUCTIONS

Svenska Nederlands Italiano Français Español Deutsch Dansk EnglishDanskDeutschItalianoNederlandsSvenska Français Español English

Using a serial effects connection with the L1 model I power stand

Note: Connecting an effects unit in serial requires a TRS split “insert” cable (with a ¼-inch TRS

connector on one side, and two mono ¼-inch phone connectors on the other). This type of cable

is readily available at most musical instrument stores and on the Internet.

1. Insert the TRS plug into the Channel 1 Insert jack on the L1 model I power stand.

2. Connect the ¼-inch mono plug (labeled “send”, “ring”, or “right”) to the input of the

effects processor.

3. Connect the other ¼-inch mono plug (labeled “return”, “tip”, or “left”) to the output of the

effects processor.

4. Adjust the effects level and mix of the effects processor.

Note: A very high output from the effects processor can overload the input of the L1 model I

power stand. If the LED on the remote turns red, even if the channel LEVEL control on the R1

remote control is below the 12 o’clock position, reduce the output level of your effects processor.

Note: The effects processor does interrupt the audio path. This may result in no audio output if

the effects processor is turned off. To use a “clean” signal, do not turn the effects processor off,

but put it in bypass mode.

Figure 8

Using a serial effects

connection

TRS

TRS split “insert” cable

Connect to

Channel 1 Insert

(Return, Left or Tip)

Connect to Effects Unit

OUTPUT

(Send, Right, or Ring)

Connect to Effect Unit INPUT

Digital Effects Unit

L1 model I power stand

PIASOG.book Page 26 Wednesday, February 14, 2007 3:10 PM

Loading ...

Bose L1 model I system