Loading ...
Loading ...
Loading ...
19
S
ETUP
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsDansk Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
Connecting two B1 bass modules
Connect the first B1 bass module to the L1 model I power stand as shown in “Connecting
one B1 bass module.”
Insert one end of the second B1 bass module cable into the unused jack on the rear panel of
the first B1 bass module. Insert the other end of the cable into one of the jacks on the rear
panel of the second B1 bass module.
CAUTION: Do not connect more than two B1 bass modules to the B1 Bass Module jack on the
L1 model I power stand. Driving more than two B1 bass modules from the B1 Bass Module out-
put will improperly load the amplifier in the L1 model I power stand resulting in poor system per-
formance.
Note: Use only the supplied (blue) B1 bass module 4-wire cable to connect B1 bass modules
to the L1 model I power stand. The L1 model I power stand uses the signals on two of the four
wires to automatically sense how many B1 bass modules are connected to it. DO NOT SUB
-
STITUTE the supplied cable with a 2-wire speaker cable.
Figure 7
Installation of two B1 bass
modules
To
B1 Bass Module
PIASOG.book Page 19 Wednesday, February 14, 2007 3:10 PM
Loading ...
Loading ...
Loading ...