Loading ...
Loading ...
Loading ...
HomeConnect en
25
10.4 Checking the signal
strength
You should check the signal strength
if no connection could be estab-
lished.
1. Press .
a lights up and the sub-
menu display shows .
2. Press / (Submenu) re-
peatedly until the submenu display
shows .
a The submenu display shows a
value between setting (no recep-
tion) and (full reception).
3. Press .
Note:The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
▶
Carry out one of the solution op-
tions:
‒ Place the router and refrigerator
closer together.
‒ Ensure that the connection is
not interfered with by screening
walls.
‒ Install a repeater to strengthen
the signal.
10.5 Installing updates for the
Home Connect software
The appliance searches for updates
to the HomeConnect software at reg-
ular intervals.
Note:If updates are available, the
submenu display shows .
To cancel the update and reset the
submenu display to the set temperat-
ure, press any touch field.
1. Press .
a lights up and the sub-
menu display shows .
2. Press / (Submenu) re-
peatedly until the submenu display
shows and the submenu setting
display shows .
3. Press (Submenu setting).
a The submenu setting display
shows an animation.
a The update is installed.
a The control panel is locked during
the installation.
a If the installation is successful, the
submenu setting display shows .
4. If the submenu setting display
shows , the appliance was un-
able to install the update.
‒ Repeat the process at a later
point.
5. If the update cannot be completed
after several attempts, contact cus-
tomer service →Page44 .
10.6 Resetting HomeConnect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the HomeConnectsettings.
1. Press .
a lights up and the sub-
menu display shows .
2. Press / (Submenu) re-
peatedly until the submenu display
shows and the submenu setting
display shows .
3. Press (Submenu setting).
a The submenu setting display
shows an animation for approx.
15seconds.
a The submenu setting display then
shows .
Loading ...
Loading ...
Loading ...